Step 1
Measure opening, cut column staves 1/8" longer.

Step 2
Snap staves together, use rubber mallet to tap. Keep staves even, they do not slide after snapped together. Snap from center of column out toward each end of column.

Step 3
Install horizontal plate with two screws into pre-drilled holes. If you have cut down the column, drill two holes 3½ from end of column. Snap pre-finished cover over plate.

Step 4
Install cap and base over ends of column. Slide cap and base on the minimum amount possible.

Legend & Elite Assembly

Step 1
Measure opening, cut column staves 1/8" longer.

Step 2
Snap staves together, use rubber mallet to tap. Keep staves even, they do not slide after snapped together. Apply Astragel on Elite column.

Step 3
Install cap and base over ends of columns. Slide cap and base on the minimum amount possible.